A premium quality two-part solvent based epoxy coating designed for maximum protection, easy application, outstanding gloss, colour retention, chemical resistance, water resistance, strong adhesion to metal, concrete and wood. The product is available in a solvent to hardener ratio of 3:1.

Technical Information

Primer Recommendations

• Epoxy Red-Oxide primer for Steel
• Epoxy Sealer for Wood and Concrete

Mixing Instructions

• Mix Base part A and Hardner part B separately with good agitation, and add Hardner part B into Base Part A and mix thoroughly until homogeneous. Allow reacting in can for about 15 min. (induction time) If thinning is necessary add thinner after 15 min induction time.
• Mixing ration of A : B is available in 2:1, 3:1 & 4:1 ratios.

Surface Preparation

• All surfaces must be sound, dry, clean and free from oil, grease, dirt ,loose /flaking paint and other foreign substances.

Suggested Uses

• Interior furniture and equipment, chemical plants, pharmaceutical plants, textile plants, refineries and on concrete where chemical, oil, grease, water and maximum abrasion resistance are required
• Interior storage tank and structure
• In water storage tank and swimming pool where maximum water resistance are required
• In pharmaceutical industries where antifungal requirements are necessary

Feature

•  For Interior Application
• Water Resistance
• Moisture Resistance
• Solvent Resistance
• Salt Spray Resistance
• Acid Resistance
• Alkali Resistance
• Fast Drying
• Low VOC
• Poor Exterior Stability
• Poor Stability at Higher Temperature

Application

• Best Application by Brush & Spray
• For large surface areas rollers are more suitable

Drying Time at 30°C & 50 RH

• Surface Dry          30 Minutes
• Tack Free              1.0 Hours
• Hard Dry               6-8 Hours
• Low Temperature, High Humidity, Thickness of film, and Poor Ventilation will increase the dry time.

Limitations

• Not recommended for application on exterior and where temperature reaches above 70°C